Skip to content

Communication Interfaces ​

The iCartridge 2.0 supports three communication interfaces: Modbus RTU over RS485, USB CDC serial, and Bluetooth Low Energy (BLE).

Modbus RTU (RS485) ​

The primary industrial interface is Modbus RTU over RS485. The device operates as a Modbus slave on the network.

Configuration ​

ParameterValue
Physical LayerRS485 (half-duplex)
ProtocolModbus RTU
RoleSlave
Slave ID0x66 (102 decimal)
Baud Rate115200 bps
Data Bits8
ParityNone
Stop Bits1
Flow ControlNone (RS485 direction controlled via DE/RE pins)

Supported Modbus Functions ​

Function CodeDescription
0x01Read Coils
0x02Read Discrete Inputs
0x03Read Holding Registers
0x04Read Input Registers
0x05Write Single Coil
0x06Write Single Holding Register

RS485 Connector ​

The RS485 interface is exposed via a DB9 (SUB-D) connector on the enclosure.

DB9 PinSignal
Pin 1RS485 A
Pin 5GND
Pin 6RS485 B

Note on RS232

The current hardware provides RS485 only. RS232 Modbus is not supported on the current revision, but can be added with a hardware change if needed.

Register Map ​

See the Modbus Register Table for the complete register mapping.

USB Serial (CDC) ​

The USB interface provides a virtual COM port (CDC) over a standard USB Type A connector on the enclosure. The USB connection is optically isolated via an ADuM4160 isolator.

USB serial supports the same binary command protocol used by BLE, enabling PC-based configuration and monitoring. The device enumerates as a standard USB CDC device -- no special drivers are needed on modern operating systems.

See the BLE / USB CDC Protocol page for the full binary protocol specification with examples.

Bluetooth Low Energy (BLE) ​

Wireless communication is provided via a DA14531MOD BLE module.

BLE UART Configuration ​

ParameterValue
Baud Rate115200 bps
Data Bits8
ParityNone
Stop Bits1
Flow ControlRTS/CTS

BLE provides wireless access to all Modbus registers via a custom binary command protocol, supporting both read and write operations. A Ping command must be sent every 5 seconds to maintain the BLE session.

See the BLE / USB CDC Protocol page for the full binary protocol specification with examples.